本帖最后由 zxw 于 2013-11-13 23:02 编辑
今天终于把WIFI和VGA显示的问题搞定了,但是还是有启动缓慢的情况。
我贴一下日志:
[ 4.568100] Freeing init memory: 212K
<6>Write protecting the kernel text section c0008000 - c07c7000
[ 4.577548] Write protecting the kernel text section c0008000 - c07c7000
<4>init: plymouth main process (69) killed by SEGV signal
[ 5.093293] init: plymouth main process (69) killed by SEGV signal
<4>init: ureadahead main process (68) terminated with status 5
[ 5.111699] init: ureadahead main process (68) terminated with status 5
[rfkill]: rfkill set power 0
<4>init: plymouth-log main process (154) terminated with status 1
<30>udevd[167]: starting version 175
pwm-sunxi: pwm0 configured - period: 20, duty_percent: 50, duty: 10
<4>init: plymouth-upstart-bridge main process (178) terminated with status 1
<4>eth%d: device MAC address ce:e7:a2:c7:d3:52
[gmac]: sun6i_gmac platform driver registration completedUMP<2>: Inserting UMP device driver. Compiled: Oct 26 2013, time: 18:30:13
UMP<2>: Using OS memory backend, allocation limit: 134217728
UMP: UMP device driver loaded
Mali: permit MALI_IOC_MEM_MAP_EXT ioctl for framebuffer (paddr=0x5A000000, size=33554432)
<6>mali: use config clk_div 1
<6>mali: clk_div 1
Mali: mali clock set completed, clock is 312000000 Hz
<6>mali: use config clk_div 1
<6>mali: clk_div 1
Mali: mali clock set completed, clock is 312000000 Hz
Mali: Mali device driver loaded
<6>sunxi_gmac: probed
<6>eth0: PHY ID 001cc915 at 0 IRQ 0 (sunxi_gmac-0:00) active
<6>eth0: PHY ID 001cc915 at 1 IRQ 0 (sunxi_gmac-0:01)
<7>eth0: no IPv6 routers present # 在这里卡住大约两分钟
Last login: Wed Nov 13 14:43:01 UTC 2013 on tty1
<6>bcmdhd: got gpio2, mapped to irqno170
dhd_customer_gpio_wlan_ctrl: call customer specific GPIO to turn on WL_REG_ON
Welcome to Linaro 13.04 (GNU/Linux 3.4.61+ armv7l)
下面都是正常的了,显示器已经能看到lubuntu的登录界面了。
非常感谢matson大神的指点,剩下这个启动缓慢的问题谁可以帮忙解决一下?
我感觉卡住似乎并不是DHCP的问题了,因为我 两个网卡(固定的和无线)都设置成静态IP了,而且启动后查看的IP也都是按配置设置的,也能够上网。
*
|