|
楼主 |
发表于 2015-5-7 08:40:29
|
显示全部楼层
sam@sam-zhan:/d/embeded/cubieboard/source/a80-linux-sdk$ cb_part_install_flash_card sdc
sdc
[sudo] password for sam:
PartSize=470166 sizeByte=235083
umount:/d/embeded/cubieboard/source/a80-linux-sdk/output/cb4/cb4-debian-server/rootfs:未找到
rm: 无法删除"/d/embeded/cubieboard/source/a80-linux-sdk/output/cb4/cb4-debian-server/rootfs": 没有那个文件或目录
Cleaning /dev/sdc
494742
Checking that no-one is using this disk right now ...
OK
磁盘 /dev/sdc:1022 个柱面,122 个磁头,62 个扇区/磁道
旧状况:
Units = sectors of 512 bytes, counting from 0
设备 启动 开头 结束 #扇区 Id 系统
/dev/sdc1 40960 65535 24576 83 Linux
/dev/sdc2 65536 786029 720494 83 Linux
/dev/sdc3 0 - 0 0 空
/dev/sdc4 0 - 0 0 空
新状况:
Units = sectors of 512 bytes, counting from 0
设备 启动 开头 结束 #扇区 Id 系统
/dev/sdc1 40960 65535 24576 83 Linux
/dev/sdc2 65536 560277 494742 83 Linux
/dev/sdc3 0 - 0 0 空
/dev/sdc4 0 - 0 0 空
Warning: partition 1 does not start at a cylinder boundary
Warning: partition 1 does not end at a cylinder boundary
Warning: partition 2 does not start at a cylinder boundary
Warning: partition 2 does not end at a cylinder boundary
Warning: no primary partition is marked bootable (active)
This does not matter for LILO, but the DOS MBR will not boot this disk.
成功写入了新分区表
正在重新读取分区表...;
If you created or changed a DOS partition, /dev/foo7, say, then use dd(1)
to zero the first 512 bytes: dd if=/dev/zero of=/dev/foo7 bs=512 count=1
(See fdisk(8).)
mkfs.fat 3.0.26 (2014-03-07)
mke2fs 1.42.9 (4-Feb-2014)
文件系统标签=
OS type: Linux
块大小=1024 (log=0)
分块大小=1024 (log=0)
Stride=0 blocks, Stripe width=0 blocks
62000 inodes, 247368 blocks
12368 blocks (5.00%) reserved for the super user
第一个数据块=1
Maximum filesystem blocks=67371008
31 block groups
8192 blocks per group, 8192 fragments per group
2000 inodes per group
Superblock backups stored on blocks:
8193, 24577, 40961, 57345, 73729, 204801, 221185
Allocating group tables: 完成
正在写入inode表: 完成
Creating journal (4096 blocks): 完成
Writing superblocks and filesystem accounting information: 完成
Make sunxi partitons successfully |
|