|
- HELLO! BOOT0 is starting!
- boot0 version : 2.0.0▒
- read dram para.
- dram driver version: 1.15
- dram size =2048MB
- 0xffffffff
- super_standby_flag = 0
- Succeed in opening nand flash.
- block from 2 to 6
- deal block 2
- Succeed in reading Boot1 file head.
- The size of Boot1 is 0x00068000.
- The file stored in 0x00000000 of block 2 is perfect.
- target="_blank">Check is correct.
- Ready to disable icache.
- Succeed in loading Boot1.
- Jump to Boot1.
- [ 0.148] boot1 version : 2.0.0
- [ 0.148] script installed early ok
- [ 0.149] pmu type = 3
- [ 0.253] bat vol = 0 mv
- [ 0.267] axi:ahb:apb=4:2:2
- [ 0.267] set dcdc2=1450mv, clock=912M successed
- [ 0.269] key
- [ 0.282] no key found
- [ 0.282] flash init start
- [ 0.282] NB1 : enter NFB_Init
- [ 0.285] NB1 : enter phy init
- [ 0.288] [NAND] nand driver(b) version: 0x0x00000002, 0x0x00000012, data: 0x20130627
- [ 0.296] get the good blk ratio from hwscan : 912
- [ 0.301] NB1 : nand phy init ok
- [ 0.346] NB1 : init ok
- [ 0.346] flash init finish
- [ 0.346] target="_blank">mbr magic is not correct
- [ 0.349] fs init fail
- [ 0.352] fs init fail, jump to fel
复制代码 启动错误,怎么解决?
http://www.whatled.com/post-1338.html
|
|